Non-woven wallpaper, also called non-woven wallpaper, is a kind of high-grade wallpaper/wallpaper. Because it is made of natural plant fiber non-woven technology, it has stronger tensile force, is more environmentally friendly, does not mold and yellow, and has good air permeability. substrate.
How to paste non-woven wallpaper:
1. Wall treatment
The wall surface should be flat, clean, dry, and uniform in color.
2. Wallpaper cutting
Arrange the wallpaper according to the serial number of the wallpaper, measure the height of the wall, and cut the wallpaper according to the height of the upper and lower parts of the wall. Remember to cut one roll of wallpaper at a time to prevent quality problems.
3. Brush wallpaper glue
The non-woven wallpaper glue must be evenly brushed on the wall with a thickness of 2mm. Never directly brush the glue on the back of the non-woven fabric, let alone soak it in water. Different from other wallpapers, non-woven fabrics should have a thicker and thicker glue than other wallpapers, making it less fluid.
4. Paste wallpaper
Post the non-woven wallpaper in the order that has been compared in advance.
5. Construction wallpaper cutting
It is necessary to overlap the edges and cut the construction. The specific method is to overlap the edges during construction. The number of edges depends on the pattern. After making sure the pattern is aligned, press down with a ruler at the overlapping place to cut, try to avoid cutting at the outside corner, so as not to cause the edge of the wallpaper at the outside corner, make sure the cutting knife is sharp when cutting, and there should be no burrs , At the same time, pay attention to the strength of the knife, to ensure that one cut and one knife break, but not too much damage to the surface of the wall.
6. Clean the wallpaper after sticking
If there is dust on the surface after construction, use a short-bristle brush or duster to flick it, and do not wipe it with a wet towel to cause pollution to expand.
Precautions for sticking non-woven wallpaper:
1. During construction, after the base coating layer is dry, draw a vertical line as a standard to avoid the incorrect position of wallpaper paste.
2. Do not use a hard scraper or nylon brush after the wallpaper is installed on the wall. You should use a soft brush to gently scrape from top to bottom to smooth the surface of the non-woven fabric to remove air bubbles and wrinkles. Do not scrape the glue out of the seam to avoid contamination. If the glue is accidentally squeezed out of the surface, wipe it off with a dry towel immediately, and try to keep your hands clean during construction.
3. During construction, inspection should be carried out at the same time as construction. If problems are found, construction should be stopped immediately, and the reasons and solutions should be found out before construction.